How To Save Electrical Objects During Water Damage Restoration Today's lifestyle is dependent on an array of electrical gadgets. All of us are familiar with electric gadgets which make our lives easier and more comfortable. Gadgets like cellular phones, PDA's, MP3 players, voice recorders and other sorts of gadgets and gizmos are our constant companions and things which we cannot do without. However these very same gadgets which give you so much comfort are often the most affected by water damage. Water can enter into your home in case of a calamity like flood PCB Prototype. Sometimes the cause may be simple. Water fills your home owing to broken pipes. Sometimes your electric gadget may accidentally fall in your bath tub or swimming pool. If your electric gadget has been affected by water, then water damage restoration is called for.

When doing water damage restoration, prompt action should be taken to save electrical gadgets which would be most likely to be wrecked. As a first step in water damage restoration, the gadget must be immediately taken out of water. Prolonged contact with water is likely to damage it beyond repair. Therefore, while working on water damage restoration, you should try to salvage your electrical equipment as quickly as possible and cut down on your losses.

The first step you should take during water damage restoration, in order to save electrical gadgets is to remove it from water. Take it to a dry place. With the help of paper towels and simple dry cloth you can remove water from its surface. However remember never to shake the concerned electrical device in order to shake off water Rigid flex PCB. This may result in more water seeping into the machine.

While water damage restoration is taking place, never switch on any electrical device or you may be forced to part with it. It may even be dangerous and lead to electrocution. Once the outer surface is dry it is necessary to make an estimate of the water that has seeped inside. Remove the outside casing and let it dry. The batteries should be removed and allowed to dry in a safe place. The next step is very important to restore your electrical device to health.

With the help of precision screwdrivers, try to remove and separate the layers of printed circuit boards or PCB's inside your device. However if you cannot get hold of specialized screwdrivers you can go in for small flat-type (minus) screwdrivers. Once you remove the screws separate the PCB layers. Water from the PCB layers can be removed with the help of cotton buds. Then you can dry the PCB layers with the aid of a low-power air blower or a hair dryer. Once the layers are dry spray the layers with a non-corrosive contact cleaner if you can get hold of it. Once the process is complete try to reassemble the parts in the same order as they were assembled. Fit in the casing and batteries. Use the screw driver once again to put the screws back in place.

Most electric devices function normally once they have been thoroughly dried during the water damage restoration process provided their exposure to water has not been of a long duration. If it fails to work initially you can recharge the batteries. The power of the battery could be discharged when it was short circuited by water. You may have to buy a new set of batteries if the previous ones don't work.
more...
http://pcbonline.2349057.n4.nabble.com/Outsourcing-The-Circuit-Board-Assembly-Processes-td7.html

15 Dec 2015